Fsb Frequency Select (By Sw1 Dip5~Dip6/Jp2) - SOLTEK SL-65KVB User Manual

2-4-1 FSB FREQUENCY SELECT (BY SW1 DIP5~DIP6/JP2)

• Over clocking is not recommended, your system may work unstable.
• SW1 DIP5~6/JP2 settings for FSB (Front Side Bus) Frequency Select is
a redundancy device designed for professional CPU overclocking only. Since
this mainboard is designed with CPU clock auto-detection function, you are
recommended to use the SW1 DIP5~6/JP2 default setting for a stable
system performance. In case of CPU overclocking to higher frequency, these
exists high possibility of failure due to the high complexity of components
adopted on board. On the other hand, selecting a lower frequency setting for
a CPU with higher frequency (e.g. select 100MHz setting for a 133MHz CPU)
will also cause system failure.
SW1 DIP5 ~ DIP6
66/100/133MHz
Auto Select
(default)
100MHz
133MHz
JP2: FSB SELECT
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
23
Chapter2 Hardware Setup
1
3
1
3
1
3