Powering On The System Console And Restoring System Files - Sun Microsystems StorEdge A7000 Service Manual

6.10.4 Powering On the System Console and Restoring
System Files
After replacement, you can now power on the System Console and restore the files
you backed up on the subsystem in Section 6.4.1 "Back Up the Current MCD to a
Subsystem" on page 6-5.
Note – On the System Console with trackpad mouse, move the pointer by putting
your finger on the trackpad; the pointer moves as your finger moves over the
trackpad.
1. Slide the power switch to the left. The System Console starts the graphical user
interface and the System Console application menu bar software (shown below):
FIGURE 6-14
2. Open a window for the System Console and each subsystem:
— Open Subsystem Windows
a. Move the mouse pointer to Windows at the Menu Bar.
b. Click and hold the left mouse button. A menu is displayed.
c. Drag the mouse pointer to dsp1. This is subsystem 1.
d. Release the mouse button. Window dsp1 is displayed and shows any
communication occurring through the Processor card's serial port 0.
Repeat these steps for the other subsystem, titled dsp2.
— Open a System Console xterm Window
a. Put the mouse pointer in any open area on the root window display area.
b. Press and hold the left mouse button. A menu is displayed.
Drag the mouse pointer to NEW WINDOW.
c. Release the left mouse button. A System Console xterm window is displayed.
System Console Application Menu Bar
Chapter 6 FRU Removal and Replacement 6-35