Parrot Uncle BBCF590 Owner's Manual page 26

13. Light Kit LED Driver Replacement
13.10
Squeeze and unclip the Motor AC Power Connector
from the Light Kit LED Driver Connector (Figure 50).
Squeeze and unclip the Motor DC Power Connector
from the Light Kit LED Driver Connector (Figure 50).
13.11
Remove the two Phillips Head Screws from the Old
Light Kit LED Driver (Figure 51).
Retain the Screws for future reinstallation.
Gently pull up on the Old Light Kit LED Driver. Remove
the Driver from the Motor Housing (Figure 51).
Discard the Old Light Kit LED Driver in the correct
recycle bin.
13.12
Place the New Light Kit LED Driver into the Motor
Housing, aligning it directly where the Old Driver had
been (Figure 52).
Install the New Light Kit LED Driver to the Motor
Housing using the two Screws previously removed
(Figure 52).
MOTOR AC POWER
CONNECTOR
LIGHT KIT
LED DRIVER
CONNECTOR
LIGHT KIT
LED DRIVER
CONNECTOR
Figure 50
REMOVE & RETAIN PHILLIPS
HEAD SCREWS (2)
OLD LIGHT KIT
LED DRIVER
Figure 51
REINSTALL THE PHILLIPS
HEAD SCREWS (2)
NEW LIGHT KIT
LED DRIVER
Figure 52
26
(Continued)
MOTOR DC POWER
CONNECTOR
LIGHT KIT
LED DRIVER