Parrot Uncle BBCF590 Owner's Manual page 24

13. Light Kit LED Driver Replacement
13.2
Remove the two Knurled Knobs and Lockwashers from
the Threaded Studs. Retain the hardware for future
reinstallation (Figure 44).
Slide the Ceiling Cover Downward to rest on top the
Motor Housing.
13.3
Slide the Receiver out of the Hanger Bracket for
disassembly of the wiring (Figure 45).
Removal of the Ceiling Fan Wires, See Section 7,
Reverse Steps 7.6 through 7.1.
Retain all hardware for future reinstallation.
13.4
Carefully remove the Ceiling Fan (hangerball / downrod)
from the Hanger Bracket.
Place the Ceiling Fan, Downrod facing up, onto
a secure solid surface in preparation of the driver
replacement.
NOTE: Be very careful not to bend the blade
assemblies while removing the ceiling fan.
13.5
Remove the Hanger Ball Pin from the Hanger Ball to
release the Hanger Ball from the Downrod (Figure 46).
Loosen the Phillips Head Set Screw to release the
Hanger Ball from the Downrod (Figure 46).
Retain both the Pin and Hanger Ball for future
reinstallation.
Figure 44
WIRE CONNECTOR
Figure 45
4.5" DOWNROD
PHILLIPS HEAD
PHILLIPS HEAD
SET SCREW
SETSCREW
Figure 46
24
(Continued)
CEILING
COVER
THREADED
STUDS (2)
LOCKWASHERS (2)
KNURLED
KNOBS (2)
OUTLET BOX
RECEIVER
PIN
HANGER
BALL