Table of Contents
Advertisement
Chapter 7 – Prestart Inspection
Platform Glazier Package
The machine may be equipped with an optional platform
glazier package.
• Inspect the glazier trays (refer to Figure 7.15) and
keeper pins to make sure they are in good condition
and are not bent or distorted. The straps and padding
must be in good condition and not worn, cut or frayed.
Padding
Straps
Keeper Pins
Figure 7.15 – Platform Glazier Package
Platform Welder
The machine may be equipped with an optional welder
mounted in the platform.
• Inspect the components, including the welder mount-
ing, welder, cables, safety decals, fire extinguisher,
etc. to verify all components are present and are in
working condition.
40
Trays
Drive Motion Alarm
The machine is equipped with a drive motion alarm.
• Operate the machine functions to ensure that the
alarm sounds to warn personnel in the area that the
aerial platform is in motion.
Placards and Decals
To inspect the placards and decals:
1. Inspect all safety and operational placards and
decals. Make certain they are in place, in good con-
dition, and are legible.
2. Clean the placards and decals with soap and water,
and a soft cloth if the words or pictures cannot be seen.
Caution
Solvents may contain hazardous ingredients. Follow
the manufacturer's label for proper use and dispos-
al. Wear protective gloves and splash-proof safety
glasses when using solvents.
3. Remove wet paint overspray using a natural biode-
gradable solvent and a soft cloth.
4. Replace any missing or illegible placards or decals
before operating the aerial platform.
Placard and decal kits are available from Snorkel.
The safety related placards and decals are illustrated on
the following pages.
460SJ – 1433685
Advertisement
Table of Contents
