Snorkel 460SJ Operator's Manual page 88

Appendix C – Inspection Checklists
Frequent Maintenance – Every 90 Days or 150 Hours
Item
Daily maintenance
Preventive inspection
maintenance checklist
Placards and decals
inspection
Door hinges and latches
Rotation bearing
Rotation bearing teeth
and pinion
Tie rods
Gear hubs
Swing drive
Platform rotator
Platform controller
Batteries
Hydraulic return filter
Engine rpm
Engine oil and filter
Engine fuel filter
Performed by:
Model Number:
Procedure
Perform maintenance as per schedule
Perform inspection, complete form
Inspect using drawing and parts listing
in Section 1 – Repair Parts Manual
Lubricate
Lubricate
Lubricate
Lubricate
Check fluid level, fill if low
Check fluid level, fill if low
Refill if disassembled for repairs
Check smooth operation/speeds
Check specific gravity
Check condition
Check for proper engine rpm
Replace per engine owner's manual
Check condition
Maintenance Table Key: P = Pass, F = Fail, R = Repaired
Information
Retain copy of checklist
Retain copy of checklist
Replace any missing or
unreadable decals/placards
SAE 10W oil or spray lubricant
Extreme pressure grease
Above 10° F NLGI Grade 2
Below 10° F NLGI Grade 1
Open gear lubricant
ASTM D 445
Extreme pressure grease
Above 10° F NLGI Grade 2
Below 10° F NLGI Grade 1
Gear lubricant SAE grade 80W-90
Gear lubricant SAE grade 80W-90
Consult factory
1.260/1.275 at 80° F (26° C)
Replace if dirty
See engine owner's manual
See engine owner's manual
Replace every 6 months or if dirty
Serial Number:
Date:
460SJ – 1433685
P/F/R