Table of Contents
Advertisement
Chapter 7 – Prestart Inspection
• Inspect the covers while operating the machine to
ensure they are securely fastened and completely
cover the cylinder rod. Make sure there are no holes
in the covers.
Air Line to Platform
The machine may be equipped with an optional air line
to the platform.
• Inspect the components, including the air line, mount-
ing hardware, and the caps on the input and output
connectors, etc. to verify all components are present
and are in working condition.
Driving and Platform Work Lights
The machine may be equipped with driving lights and/or
platform work lights.
• Turn the engine on and use the switch on the upper
control panel to momentarily turn the lights on to verify
proper operation.
Tow Kit
The machine may be equipped with an optional tow kit.
• Inspect the components, including the tow bar, steer
arm, and chains, etc. to verify all components are
present and are in working condition.
Platform Glazier Package
The machine may be equipped with an optional platform
glazier package.
• Inspect the glazier trays (refer to Figure 7.17) and
keeper pins to make sure they are in good condition
and are not bent or distorted. The straps and padding
must be in good condition and not worn, cut or frayed.
Padding
Straps
Keeper Pins
Figure 7.17 – Platform Glazier Package
36
Trays
Platform Welder
The machine may be equipped with an optional welder
mounted in the platform.
• Inspect the components, including the welder mount-
ing, welder, cables, safety decals, fire extinguisher,
etc. to verify all components are present and are in
working condition.
Placards and Decals
To inspect the placards and decals:
1. Inspect all safety and operational placards and
decals. Make certain they are in place, in good con-
dition, and are legible.
2. Clean the placards and decals with soap and water,
and a soft cloth if the words or pictures cannot be seen.
Caution
Solvents may contain hazardous ingredients. Follow
the manufacturer's label for proper use and dispos-
al. Wear protective gloves and splash-proof safety
glasses when using solvents.
3. Remove wet paint overspray using a natural biode-
gradable solvent and a soft cloth.
4. Replace any missing or illegible placards or decals
before operating the aerial platform.
Placard and decal kits are available from Snorkel.
Safety related placards and decals are illustrated on the
following pages. Refer to the appropriate decal page in
the machine parts manual for specific operational and
safety placards and decals.
A46JRT – 0260996
Hide quick links:
Advertisement
Table of Contents
