Table of Contents
Advertisement
7.8
Fault Action Parameter
The "Fault Action" parameter is used to control outputs during a communication failure.
The user can determine how the states of the outputs are affected when a communication fault occurs.
The Fault Action parameter is set through the graphic display advanced settings menu or the integrated
webpage's node configuration page.
The options are:
3.
Hold Last State of Outputs
4.
Turn Off All Outputs
Fault Action Sequence Flowchart
Turn OFF
All Outputs
Outputs
De-Energize
Distributed by Valin Corporation | www.valin.com | (800) 774-5630 | customerservice@valin.com
TM
580 EtherCAT
Communication
Fault Received
Device
Checks
Communication
Fault
Attribute
TD580ECTM1-3EN
Subject to change without notice
www.emerson.com
Technical Manual
Hold Last State
Outputs
Do Not
Change State
09/2021
7-60
Advertisement
Table of Contents
