Table of Contents
Advertisement
580 EtherCAT
10. Choose the option marked "Use the following IP address" and type in an IP address that has the same first
three octets as the address that you will set the manifold to. For the last octet you may choose any number
from 0-255, just make sure that it is not the same number as the IP address that the manifold will have.
Make sure your subnet mask is set to "255.255.255.0" (this value can be changed, but this value will be
used for demonstration purposes).
11.
Left click "OK" in the "Internet Protocol (TCP/IP) Properties" and "Local Area Connection" windows for the
changes to take effect on the computer. Close out of any open windows.
Once the IP address for the computer is known, you can set the IP address of the Aventics manifold using one
of the methods described on page 6-30.
12.
Click on "start" then select "All Programs->Accessories->Run".
Distributed by Valin Corporation | www.valin.com | (800) 774-5630 | customerservice@valin.com
TM
Technical Manual
TD580ECTM1-3EN
09/2021
Subject to change without notice
www.emerson.com
7-50
Advertisement
Table of Contents
