Connector Pin-Outs - Emerson Aventics EtherCAT 580 Technical Manual

4.3

Connector Pin-Outs

Industry standard M12 connectors are used for communication and power.
The EtherCAT TM Communication connector is a D-Code 4 pin Female M12 connector.
The Power connector is a M12 5 pin male connector.
Communication Connector Pin-Out
Pin No. Function
1
2
3
4
Power Connector Pin-Out
Pin No.
1
2 0 VDC Common (Valves)
3 0 VDC Common (Node)
4
5
 Power common (0 VDC) pins 3 and 4 are isolated from each other to allow separate
! (isolated) power supply connection if required. However, they can be tied together if a single
common, non-isolated, application is preferred.
 The draw of the +24VDC Valves and +24VDC Node pins must not exceed 4 Amps.
 The Node pins supplies power to the node electronics. These pins must be powered at all
times for communication node to be functional.
 To be connected to Class 2 power source only
Distributed by Valin Corporation | www.valin.com | (800) 774-5630 | customerservice@valin.com
580 EtherCAT
TX+
RX+
TX-
RX-
Function
+24 VDC (Node)
+24 VDC (Valves)
FE
TD580ECTM1-3EN
Subject to change without notice
www.emerson.com
TM
Technical Manual
Description
Positive Transmit Line
Positive Receive Line
Negative Transmit Line
Negative Receive Line
Description
Voltage used to power node electronics UNSW
0 VDC Voltage used to power outputs (Valves) SW
0 VDC Voltage used to power node electronics UNSW
Voltage used to outputs (Valves) SW
Functional Earth
09/2021
4-15