SIMAG SPN Use And Maintenance page 6

INSTALLATION INSTRUCTIONS
Installation must be performed by
authorized technicians.
When installing the appliance, replace
the existing water supply tubes with the
new ones supplied with it.
Place the water drain hose(s) supplied in
the relative drain.
Attention, use only drinking water.
The water supply tap must be within
reach of the operator.
The installation of a softener filter for the
water connection is recommended. For
the installation, contact your local official
distributor.
Before installation and periodically
during use, check that the power cable
is not torn or damaged.
If the power cable is damaged, have it
replaced ONLY by QUALIFIED
PERSONNEL in order to prevent any risks.
It is mandatory to connect the appliance
to a wall switch installed on the power
line.
Do not place multiple sockets or portable
sockets behind the application.
The main switch and/or the electrical
outlet must be close to the appliance
and within reach of the operator.
During the installation, check that:
- the socket of the power supply line is
earthed.
- the contact opening distance allows
complete disconnection in the conditions
of category III overvoltage. Disconnec-
tion devices must be incorporated into
the power supply in compliance with the
installation rules.
- the appliance has a minimum distance of
150 mm from the walls to allow sufficient
ventilation;
- the appliance is perfectly level.
6
REFRIGERANT GAS SAFETY WARNINGS
Propane is a highly flammable gas.
The appliance contains fluorinated
greenhouse gases governed by the
Kyoto protocol, in the quantities indicated on
the serial plate.
The GWP (Global Warming Potential) of:
HFC R404A is 3750;
•
HFC R452A is 2140;
•
HFC RE134A is 1430;
•
R290 is 3.
•
The propane used in refrigeration systems
is odourless and heavier than air; in case of
refrigerant leaks it migrates to the ground.
The system is hermetically sealed.