SIMAG SPN Use And Maintenance page 10

KNOWING THE BUTTONS AND LIGHTS
Indicator lights "B" give useful information on the status of the machine.
F03
Powered appliance warning light
If on, it indicates that the appliance is electrically powered (plug inserted and the main switch of the room
system in the ON position).
Container full warning light
If on, it shows that the ice container is full: remove the granular ice.
Alarm warning light
If on, it indicates that the appliance is unable to load the water required for ice production: make sure that
the water supply tap is open, that the water supply hose is not disconnected, damaged or pinched and
that there is no interruption of the water supply. If the problem persists, contact Technical Service.
Alarm warning light
If on STEADY, it highlights an alarm due to the cooling condenser excessive temperature.
If on FLASHING: the device is equipped with a delay device so it starts working after 3 or 60 minutes
(depending on the model) from powering it up; during these minutes the LED flashes to indicate waiting.
Alarm warning light
If on STEADY, it indicates an alarm due to the incorrect rotation or speed of the auger; it is necessary to
contact Technical Service.
If on FLASHING, it highlights an alarm due to the evaporator excessive temperature; it is necessary to
contact Technical Service.
F03
10