SIMAG SPN Use And Maintenance page 5

If the power cable is damaged, have it
replaced ONLY by QUALIFIED
PERSONNEL in order to prevent any risks.
Before carrying out any routine cleaning
or extraordinary maintenance, it is
necessary to disconnect the appliance from
the power supply, close the water tap and
wear suitable personal protective equipment
(e.g. gloves, etc.).
If the appliance does not work or
functional or structural alterations are
noted, disconnect it from the power and
water mains (if provided) and contact a
service centre authorised by the
Manufacturer without attempting to repair it
on your own. The use of original spare parts
is mandatory. The Manufacturer accepts no
liability for the use of non-original spare
parts.
If the appliance is being repaired,
highlight with appropriate signs placed in
a visible position that it CANNOT be used.
Do not place objects that cause poor
ventilation on and around the appliance.
In particular, make sure that the front and/or
side ventilation openings are always free
from obstructions.
Do not store explosive substances in this
appliance, such as aerosol cans with
flammable propellant.
Do not use electrical devices inside the
application container, unless they are of
the type recommended by the Manufacturer.
Do not place any solid or liquid object on
top of the appliance and do not use it as
an anchor.
Do not sit on top of the appliance.
Do not work on the appliance with wet
hands or bare feet.
For small movements of the appliance, it
must always be lifted. NEVER push or
drag it.
The rating plate provides important
technical information that is vital in case
of a request for maintenance or repair of the
appliance: please do not remove, damage or
modify it.
To ensure the best conditions of use and
safety of the appliance, once or twice a
year (or according to the provisions of the
national regulations in force) contact the
Dealer or the local distributor to have the
appliance checked so that it undergoes
extraordinary maintenance (washing,
descaling and sanitizing the water circuit
and replacing the XSafe lamp - if any).
The Manufacturer's warranty does not cover
oxidation due to installations in marine
environments or in the presence of salt.
The state of appliance stopped, detected
by means of a visual inspection of the
same, does not guarantee with certainty
that the device is turned off. In order to
protect his own safety, the operator must
check that the appliance is not live, i.e. that
its plug is disconnected or that the switch on
the panel to which it is connected is in the
"OFF" position.
This manual is an integral part of the
appliance and must accompany it
throughout its useful life. Store the manual
carefully, in a dry and accessible place, near
the location of the device for any further
future consultation by the various operators
when they need it.
The appliance must be easily moved for
any extraordinary maintenance: pay
attention that any masonry work subsequent
to installation (e.g. construction of walls,
replacement of doors with narrower ones,
renovations, etc.) do not hinder movement.
Caution! Do not install the appliance on
containers with an area smaller than the
base of the appliance.
When cleaning any part or accessory do
NOT use:
abrasive or powder detergents;
•
aggressive or corrosive detergents (for
•
example hydrochloric or sulphuric acid,
caustic soda, etc.). Caution! Never use
these substances also when cleaning the
floor under the appliance;
abrasive or sharp tools (for example abrasive
•
sponges, scrapers, steel brushes, etc.);
steamed or pressurised water
•
jets.
5