SIMAG SPN Use And Maintenance page 12

After a few minutes the first ice will be released which can then be removed from the container using the scoop
F05
provided. Then, more ice will be released, until the container is filled, without the need to press any button.
To avoid overfilling the built-in container and possible leakage of the ice, inside the container there is
a sensor that stops production if the maximum capacity level is exceeded; when the "container full"
light comes on, the ice container is full and ice production is temporarily interrupted. When the ice is
removed and the level is lowered, the "container full" light goes off and the appliance automatically
resumes production without the operator needing to intervene in any way.
After removing the ice, the scoop must be placed inside the collection container on the appropriate support (if any);
to avoid contamination of the ice, use only the scoop provided and sanitize it frequently.
Ice production stop
F04
4 To stop production, pull the plug or turn OFF the switch that powers the socket or the electrical panel to which
the appliance is connected.
Turning the appliance off
To turn the appliance off, for example to carry out cleaning or at the end of the working day, unplug the appliance or
turn off the switch that powers the socket or the electrical panel to which the appliance is connected.
SMI | SPR series
These ice makers have
a built-in ice container:
door "A" must be lifted to
remove the ice.
If ice is not being
removed, the ice
container door must be
kept closed.
12
ice container door "A"
water loading for cooling (only for machines with water
condensation)
F05
water loading for ice
production
water supply tap
B
A
depending on the model
there may be a plug
and a switch
A
disconnect it if it is in a
difficult position or an
electrical panel
C
to
B
C