Operating Instructions - Alarm - CrimeStopper The Informer II CS-2016FM Operation Instructions Manual

Active Arming / Locking:
Press button #1 (Lock symbol) on the transceiver. The System will arm emit one siren
chirp, one light flash, and the LED will begin to flash.
equipped). Starter disable circuit will turn on.
displaying a Down Arrow and a Lock symbol followed by the CSP logo. After a short
delay to allow the vehicle and electronics to settle, the system will be completely armed.
Disarming: / Unlocking
Press button #2 (Unlock symbol) on the transceiver. System will disarm and confirm
with two siren chirps, two light flashes, and the LED will turn off. Power locks will Unlock
and Interior Dome light will turn on (if installed with these optional features). LCD Pager
will beep twice while displaying an Up Arrow and an Unlock symbol followed by the CSP
logo.
Alarm Triggers:
If there is an intrusion into the vehicle, a hard impact to the body, or the ignition is turned on the alarm will
sound and flash the lights for 1 minute. After 1 minute, the trigger cycle will automatically stop and alarm will
remain armed to continue protecting the vehicle. If a door is left open after an intrusion then the unit will cycle
a maximum of 5 minutes and continue to protect the other un-tampered or unopened zones.
LCD Remote Paging / Zone Violations:
When the system is triggered, the alarm sends a paging signal to the remote. If you are within range, you will
receive a violation paging signal which consists of a vibration followed by 15 audible beeps to notify you the
vehicle has been tampered with.
PM
DOOR TRIGGER

OPERATING INSTRUCTIONS - ALARM

PM
SHOCK TRIGGER
Power locks will lock (if
LCD Pager will beep once while
PM
HOOD/TRUNK TRIGGER
5
PM
ARM/LOCK
PM
DISARM/UNLOCK
IGN
(<<<< MOVING <<<<<)
PM
IGNITION TRIGGER