Transceiver / Pager-Remote - CrimeStopper The Informer II CS-2016FM Operation Instructions Manual

2-way fm paging alarm & remote engine starting system

Hide thumbs Also See for The Informer II CS-2016FM:

Installation handbook (30 pages)

Table Of Contents

Table of Contents

PAGER / REMOTE TRANSCEIVER:

The hand-held remote transceiver is used to send and receive

information from the vehicle. The Control Module transmits High

Frequency FM signals from the vehicle to your over long

distances. Your range will vary depending on location, terrain,

and local RF noise/interference. This system is not guaranteed

to page you if you are behind concrete walls, underground, in a

large structure, or in an area with high levels of electronic

interference.

Handle the pager/remote with care if the LCD

display and/or the electronics may be damaged if subjected to

abuse.

The AAA Cell 1.5V alkaline battery can easily be

replaced by sliding open the battery access door on the back of

the remote. Battery life will vary depending on usage. The LCD

screen will display a low battery icon when the battery is low.

For more on range, see "Range Questions" on page 15.

ACTIVE 2-ZONE LCD DISPLAY:

The unique LCD screen includes both a Dot Matrix animated display and a vehicle icon. It is designed to show you

both Icon-based information and animated messages in real time as it is happening. When the alarm is disarmed or

armed with no activity to report, then dot matrix portion of the screen will remain BLANK.

BUTTON 1(Lock Symbol):

• Press and release to Arm/Lock system.

• Press and Hold for more than 3 seconds to activate "Panic" feature.

BUTTON 2 (Unlock Symbol):

• Press and release to Disarm/Unlock system, or reset a cycle.

BUTTON 3 (Trunk Symbol):

• Press and Release to activate trunk pop (Auxiliary output #1) Optional

Feature.

• Press and Hold to activate a second optional feature (Auxiliary output

#2).

BUTTON 4 (Key):

• Press and release to Start/Stop engine.