Vehicle Operation - CrimeStopper The Informer II CS-2016FM Operation Instructions Manual

2 VEHICLE CONTROL
Your CS-2016FM remotes have the ability to control a second vehicle with a Crimestopper CS-2016FM or
older CS-2015FM system installed. See diagram below on how to switch your remote(s) to vehicle #2
operation.
To set up the 2-Vehicle operation you
must first program your remotes to
Vehicle #2. Follow the "Transmitter
Programming" steps (Pg. 13) at the
second vehicle and learn YOUR remote,
along with vehicle #2's existing remotes.
2-VEHCLE OPERATION NOTES:
(1) You do not have to switch between
Vehicle I and II to get pages from each
vehicle. Your remote pager will receive
pages from both cars regardless of
which vehicle the pager is set to. The "I"
or "II" icon will always display with each
page indicate which vehicle the page
originated from.
(2) When programming
systems, all remote/pagers and sidekick
remotes for that vehicle must be learned
at the time of programming. When you
program your remote at the second
vehicle, that vehicle's original remote
must also be programmed. Your remote
should be set in Vehicle II and the
vehicle's original remote should be set in
Vehicle I.

2 VEHICLE OPERATION

CrimeStopper
CS-2016FM
Press & release side
button, then you have
4 seconds to
control vehicle #2.
VEHICLE #2 CONTROL:
"Sidekick"
Remote
17
CS-2016FM
PM
START
Press & hold side button
for 5 seconds. Remote
will beep and "II" icon will
appear in lower right LCD.