Attaching The Antenna; Removing And Attaching The Accessory Connector Cover - Motorola APX 8000XE User Manual

You can view the status of the battery if the radio is using an IMPRES 2 battery.
NOTICE:
User is notified if radio detects non-Motorola Solutions battery upon powering up, charging, or
removing from the charger. This feature is applicable for IMPRES and Non-IMPRES battery.
User is notified if radio detects non-Motorola Solutions battery upon powering up, charging, or
removing from the charger. This feature is applicable for IMPRES 2 and Non-IMPRES battery.
When the radio is attached with the non-Motorola Solutions battery, a tone sounds, display
shows Unknown Battry temporarily and battery indicator is not shown in the radio display.
Battery menu screen displays Unknown Battry permanently and IMPRES battery information
is not shown on the radio display.
When the radio is attached with the non-Motorola Solutions battery, a tone sounds, display
shows Unknown Battry temporarily and battery indicator is not shown in the radio display.
Battery menu screen displays Unknown Battry permanently and IMPRES 2 battery
information is not shown on the radio display.
Procedure:
1 Slide the battery into the radio frame until the side latches click into place.
2 To remove the battery, turn the radio off. Squeeze the release latches at the bottom of the
battery until the battery releases from the radio.
2.3

Attaching the Antenna

Prerequisites:Ensure the radio is turned off before attaching the antenna.
Procedure:
1 Set the antenna in the receptacle.
2 Turn the antenna clockwise to attach to the radio.
3 To remove the antenna, turn the antenna counterclockwise.
NOTICE: When removing the antenna, ensure that the radio is turned off.
2.4

Removing and Attaching the Accessory Connector Cover

The accessory connector is on the antenna side of the radio. It is used to connect accessories to the
radio.
NOTICE: To prevent damage to the connector, shield it with the connector cover when not in
use.
Procedure:
1 To remove the accessory connector cover, rotate the thumbscrew counterclockwise until it
disengages from the radio.
NOTICE: If the thumbscrew is too tight, use an Allen wrench at to loosen it.
2 Rotate and lift the connector cover to disengage it from the radio.
3 To attach the accessory connector cover, insert the hooked end of the cover into the slot above
the connector.
MN002667A01-AR
Chapter 2: Preparing Your Radio for Use
17