Truss Bridge Assembly
Incorporating the FasTrack girder bridge(s)
E
ach track mating pier has been designed to allow you to incorporate a FasTrack Girder
Bridge (available separately, 6-81248) as a lead into the FasTrack Extended Truss Bridge. If
the girders are mounted to the top of the girder bridge base simply snap the girder bridge into
the track mounting top pier half as shown below.
Bridge
Figure 9. Using the girder bridge
Should you choose to place the girders on the underside of the girder bridge base simply
remove the two inserts in the track mounting top pier half as shown below in figure 10. Using
a Phillips head screwdriver carefully remove the pier inserts to accommodate the girders of
the FasTrack girder bridge.
Track mounting
pier half
Figure 10. Removing the insert screws
Bridge pier
Track pier
half
half
Inserts
Underside of
pier half
9
Girder bridge
(available separately,
6-81248)
Remove screws