Truss Bridge Basics; Unboxing Your Fastrack Extended Truss Bridge - Lionel FasTrack 78-2110-250 Owner's Manual

Truss Bridge Basics

Unboxing your FasTrack Extended Truss Bridge

O
nce you have the bridge removed from the polyfoam carefully slide the piers in the vac
form out of the interior of the bridge. Once the piers have been removed you can install
the upper front girder face of the bridge. This piece is located in the upper left corner of the
polyfoam. Using a #0 Phillips head screwdriver remove the 4 screws installed in the open end
of the bride.
Remove
screws
Figure 1. Removing the 4 screws
Carefully install the upper girder to the bridge by inserting the screws through the die cast face
and threading the screws into the plastic girder detail behind the bridge structure. It is
important that the screws be threaded into the plastic girder details to securely hold the upper
girder face and the plastic girder details firmly in place. Note the girder does not have a specif-
ic orientation.
Install
screws
Figure 2. Installing the upper girder
Upper Girder
4
Remove
screws
Install
screws