How To Use Electric Home Shower; How To Use - Panasonic DH-3VL1 Operating And Installation Instructions

HOW TO USE ELECTRIC HOME SHOWER

HOW TO USE

For all destinations except Vietnam:
1. Turn the Water Volume Knob anticlockwise to turn on the water
(make sure the Main Water Valve is on).
(Water will fl ow out from Shower Head at inlet water temperature).
2. Switch On the Miniature Circuit Breaker (MCB) and ON/OFF DP
(double pole) Switch.
3. Push up the ELB Reset Lever if it is down.
4.
Turn the Power Knob to On (ELB indicator LED will light on).
5. The shower temperature can be gradually controlled by turning the Power Knob.
If turn the Power Knob clockwise the shower temperature will increase, reaching the highest temperature at 'High'.
• If Water Volume Knob is turning at anticlockwise the volume of water will increase thus the water temperature will
decrease.
• If Water Volume Knob is turning at clockwise the volume of water will decrease thus the water temperature will
increase. (Please refer WATER FLOW RATE ADJUSTMENT at page EN8).
For Vietnam only:
1. Turn the Water Volume Knob anticlockwise to turn on the water
(make sure the Main Water Valve is on).
(Water will fl ow out from Shower Head at inlet water temperature).
2. Switch On the Miniature Circuit Breaker (MCB) and ON/OFF DP
(double pole) Switch.
3. Push up the ELB Reset Lever if it is down. The ELB indicator LED will light
up indicating that the set is in the on state.
4.
Turn the Power Knob clockwise to desire shower temperature.
5. The shower temperature can be selected by setting the Power Knob as below:
a) When the Power Knob is at Off, outlet temperature same with inlet water temperature.
b) For model DH-3VP1 and DH-4VP1,
When the Power Knob is set to on, DC Pump is switched on and outlet temperature same with inlet water temperature.
c) When the Power Knob is set at Low, Power Level is low.
d) When the Power Knob is set at Med, Power Level is medium.
e) When the Power Knob is set at High, Power Level is high.
• If Water Volume Knob is turning at anticlockwise the volume of water will increase thus the water temperature will
decrease.
• If Water Volume Knob is turning at clockwise the volume of water will decrease thus the water temperature will
increase. (Please refer WATER FLOW RATE ADJUSTMENT at page EN8).
6. For model DH-3VS1 / DH-3VP1 / DH-4VS1 /
DH-6VS1 only:
Select the preferred shower mode with the
Shower Select Button.
Please press the button fully.
Press
Shower Select
Button
Shower Head
Spot Shower
Normal Shower
Wide Shower
ELB: ON condition
ELB: ON condition
Note:
When stop the water fl ow or change
water shower selection from Wide
Shower to Spot Shower, some water
will continue to drip from Shower
Head for less than 2 minutes. This is
normal due to some water remain in
the Shower Head and no abnormality
to the Unit.
EN7
ELB: OFF condition
ELB: OFF condition