How To Install - Panasonic DH-3VL1 Operating And Installation Instructions

HOW TO INSTALL

WARNING
During installation process make sure
electric and water supply is turn OFF.
1. Where to install the Unit.
• Be sure to install the Unit on the wall as illustrated
in Figure 1 (vertical position with the water fi ttings
pointing downward).
• Do not install the Unit away from wall surface as
shown in Figure 2.
• The Unit must be installed at 1.5 m ~ 1.7 m
above the fl oor.
2. How to remove the Front Plate.
Make sure the Power Knob is at Off
condition.
Remove the screw at the bottom of the Unit.
Lift up the Power Knob to make it loose
(Power Knob is attached to shaft inside the
Unit). Make sure the Power Knob is not
detached from the Front Plate.
Remove the Front Plate by lifting up the
bottom side and then unhook the top side.
3. How to fi x Electric Home Shower.
The distance of the Unit should be more than 250 mm from the right and left of the wall.
Make 4 holes in the wall using a drill. The location of the hole position as shown in the INSTALLATION TEMPLATE
provided.
Drive a Wall Plug into the hole.
mm
Lead the Flexible Cord to the set thru Portion 1 as shown below for electric wiring process.
CAUTION
Cold Water
Service Valve
For DH-3VP1 / DH-4VP1
Note:
Power Knob is attached to Front Plate. Do not remove Power Knob
from Front Plate.
118 mm
Ø6 mm
mm
86 mm
188 mm
Flexible Cord must enter the Unit thru designated point only
(do not make additional holes).
EN14
Main Pipe Rising Level
Tank
33 ft (10 meter) maximum
recommended height between
bottom of cold water tank
and top of Home Shower
Unit.
OFF OFF OFF OFF MA MA MA MA
* Maximum total length
1.5 m ~
of feeding pipe should
1.7 m
be below 10 meter.
* The feeding pipe
should be 1/2 inch.
For DH-3VL1 / DH-3VS1 /
Power Knob
25 mm
Wall Plug
View from inside of the Unit
Portion 1
OFF OFF OFF OFF MA MA MA MA
1.5 m ~
1.7 m
DH-3WL1 / DH-4VL1 /
DH-4VS1/ DH-6VS1
Lift up
Front Plate
Screw
Installation Template
Figure 1
Figure 2