Table of Contents
Advertisement
PRE-RIDE INSPECTION
The pre-ride inspection is very important prior to operating the watercraft.
Always check the proper operation of critical controls, safety features and
mechanical components before starting. If not done as specified here,
severe injury or death might occur. Bring all safety equipment required by
local laws.
For more detailed information on these items, refer to the applicable sections.
Engine should be off and the DESS key should always be removed from
its post prior to verifying any of the following points. Only start watercraft
once all items have been checked and operate properly.
ITEM
Hull
Jet pump water intake
Bilge
Battery
Fuel tank
Engine compartment
Engine oil level
Engine coolant level
Steering system and side
vanes (O.P.A.S.™)
Throttle system
Shifter system
Variable Trim System (VTS)
Storage compartment covers
and seat
Self-contained removable
storage bin
Wakeboard rack
Ski/wakeboard post
DESS post and engine
start/stop button
Ballast tanks
________
WARNING
WARNING
Inspect.
Inspect/clean.
Drain. Ensure plugs are secured.
Inspect tightness of cables and retaining
fasteners.
Refill.
Verify for leaks or gasoline odor. Verify fuel
exhaust components integrity.
Check/refill.
Check/refill.
Check operation.
Check operation.
Check operation.
Check operation.
Ensure they are closed and latched.
Ensure it is installed on vehicle and properly
closed and latched.
– Ensure rack is installed properly.
– Make sure bungee cords are in good condition.
– Ensure wakeboard is installed properly.
Inspect and check operation.
Check operation.
Ensure tanks are properly installed and latched.
SAFETY INFORMATION
OPERATION
________
✓
33
Advertisement
Table of Contents
