Table of Contents
Advertisement
Note: Use an IPv4 address for the DMZ server.
Note: Enter the IP address of the default server in the Default Server Address field, and click
Apply to active the DMZ host. Otherwise, clear the IP address in the Default Server
Address field, and click Apply to deactivate the DMZ host.
Figure 139 Network Setting > NAT > DMZ
The following table describes the fields in this screen.
Table 81 Network Setting > NAT > DMZ
LABEL
Default Server
Address
Cancel
Apply
11.5 The ALG Screen
Application Layer Gateway (ALG) allows customized NAT traversal filters to support address and port
translation for certain applications such as File Transfer Protocol (FTP), Session Initiation Protocol (SIP), or
file transfer in Instant Messaging (IM) applications. It allows SIP calls to pass through the Zyxel Device.
When the Zyxel Device registers with the SIP register server, the SIP ALG translates the Zyxel Device's
private IP address inside the SIP data stream to a public IP address. You do not need to use STUN or an
outbound proxy if your Zyxel Device is behind a SIP ALG.
Use this screen to enable and disable the NAT and SIP (VoIP) ALG in the Zyxel Device. To access this
screen, click Network Setting > NAT > ALG.
Chapter 11 Network Address Translation (NAT)
DESCRIPTION
Enter the IP address of the default server which receives packets from ports that are not
specified in the NAT Port Forwarding screen.
Note: If you do not assign a Default Server Address, the Zyxel Device discards all
packets received for ports that are not specified in the NAT Port Forwarding
screen.
Click Cancel to restore your previously saved settings.
Click Apply to save your changes.
VMG/XMG Series User's Guide
232
Advertisement
Table of Contents
