Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 64 Policy Route: Add/Edit
LABEL
Active
Route Name
Source IP
Address
Source Subnet
Mask
Protocol
Source Port
Source MAC
Source Interface
(ex: br0 or
LAN1~LAN4)
WAN Interface
Cancel
OK
9.5 The RIP Screen
Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
Click Network Setting > Routing > RIP to open the RIP screen.
Figure 123 Network Setting > Routing > RIP
The following table describes the labels in this screen.
Table 65 Network Setting > Routing > RIP
LABEL
#
Interface
Chapter 9 Routing
DESCRIPTION
Click this switch to enable or disable the policy route. When the switch goes to the right
function is enabled. Otherwise, it's not.
Enter a descriptive name of up to 8 printable English keyboard characters, not including spaces.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Type the name of the interface from which the matched traffic is sent.
Select a WAN interface through which the traffic is sent. You must have the WAN interface(s)
already configured in the Broadband screens.
Click Cancel to exit this screen without saving.
Click OK to save your changes.
DESCRIPTION
This is the index of the interface in which the RIP setting is used.
This is the name of the interface in which the RIP setting is used.
VMG/XMG Series User's Guide
202
, the
Advertisement
Table of Contents
