Configuring The Camera - Foxtech SYK-10L AI User Manual

Configuring & Updating Firmware
Ensure the gimbal and the GCU have both been updated to the latest
firmware before use. Otherwise, usage may be affected.
Ensure the diver of the config module is installed on the computer
before configuring or updating the firmware.
Before configuring, the computer should be set to a static IP address,
which is in the same network segment with the GCU and the camera
(without IP address conflicts). The default IP address of the GCU and
the camera are 192.168.1.121 and 192.168.1.108.
Do not power off the device while updating the firmware. Restart the
device once firmware update is complete.

Configuring the Camera

1. Connect the gimbal and the GCU with the gimbal control cable. Connect
the computer and the net port of the GCU with the network conversion
module. Power on the devices.
2. Visit http://192.168.1.108/cgi-bin/config on the computer (if the IP address
of the camera has been changed, the IP address in the URL should be
replaced with the current camera IP address).
3. Configure the camera in the web page, and click"save"to enable the
configuration.
SYK-10L AI User Manual
2023 FOXTECH All Rights Reserved 4