Foxtech SYK-10L AI User Manual page 3

Caution
1. The SYK-10L AI equipped with a laser night vision module, which is a Class
3B invisible laser. DO NOT exposure eyes to the beam within 12 meters
or observe the beam by any optical instrument. DO NOT place any
inflammable within 20 centimeters in front of the lighting module.
2. When not in use, store the SYK-10L AI in the package box. The
recommended storage environment is a relative humidity less than 40% at
a temperature of 20±5° C. If the lenses fog up. The water vapor will usually
dissipate after turning on the device for a while.
3. Do not place the product under direct sunlight, in areas with poor
ventilation, or near a heat source such as a heater.
4. Do not frequently power on/off the product. After it is turned off, wait at
least 30 seconds before turning back on, otherwise the product life will be
affected.
5. Make sure the gimbal port and gimbal surface are free from any liquid
before installation.
6. Make sure the gimbal is securely installed onto the aircraft, the microSD
card slot cover is clean and firmly in place.
7. Make sure the gimbal surface is dry before opening the microSD card slot
cover.
8. Do not plug or unplug the microSD card during use.
9. Do not touch the surface of the camera lenses and keep it away from hard
objects. As doing so may lead to blurred images and affect the imaging
quality.
10. Clean the surface of the camera lenses with a soft, dry, clean cloth. Do not
use alkaline detergents.
11. When not receiving valid carrier INS data, the yaw shaft of the gimbal will
drift about 15 degrees per hour because of the earth rotation. To make sure
the gimbal attitude corrects, it is necessary to transmit valid carrier INS
data, usually the GNSS should be positioning.