Service Manual
N2 Controls
30
Series 51 Two Position Controls Service Manual
Inspection
Clean and inspect components for damage or foreign material. Replace damaged parts as necessary.
Assembly
1. Lubricate and install new O-ring (M12) to plug (M10).
2. Install the plug (M10) to the four-way valve cavity in the end cap.
3. Using petroleum jelly to retain them, install new interface O-rings (G36, G38, G42) on the end cap, or
install gasket (G420).
4. Install cover plate (M1).
5. Install screws (M14). Torque as shown in the table.
6. If previously removed, install a new seal washer (M16) on plug (M18). Using a 13mm hex wrench,
torque to 18 N•m [13.3 lbf•ft].
7. Using a 3 mm internal hex wrench, install orifices (T1, T2, T3) if used. Torque to 6 N•m [4 lbf•ft].
8. Lubricate and install new O-rings (G30A) onto plugs (G30). Using a 3 mm internal hex wrench, install
plugs. Torque to 9 N•m [7 lbf•ft].
11009442 • Rev CA • January 2015