Solenoid Assembly; T1/T2/T3/T4 Controls - Danfoss 51 Series Service Manual
Bent axis motors two position controls
Hide thumbs
Also See for 51 Series:
- Service manual (64 pages) ,
- Repair instructions (36 pages) ,
- Service kit instructions (2 pages)
Table of Contents
Advertisement
Service Manual
T1, T2, T3, T4, TA, TH, TM, TN
28
Series 51 Two Position Controls Service Manual
Solenoid Assembly
T1/T2/T3/T4 controls
1. Lubricate and install O-ring (M1A). Install solenoid stem.
2. Using a thin 3/4 inch wrench on the flats provided, torque to 47 N•m [35 lbf•ft].
3. Install coil with O-rings.
4. Install plastic nut. Tighten by hand.
Solenoid assembly
(TM, TN)
(solenoid may be on
either side of spool)
M1
O-ring
M1A
M1
Solenoid
(T1/2/3/4)
thin 3/4 inch
wrench
O-ring
Coil
O-ring
Plastic nut
11009442 • Rev CA • January 2015
P107 828E
Advertisement
Table of Contents
