Table of Contents
Advertisement
Rack and pinion transport platform PT-450
ID plate and features of the device:
The parachute is equipped with an identification plate, with CE logo stamped and brake characteristics:
•
Brake type, mounting position and lock sense.
•
Locking speed (r.p.m.) and brake torque (N·m)
•
Number, date and reference of manufacture.
4.3. Installing the parachute.
The unit shall be firmly fixed to the chassis of the cage, so that the pinion is centered with the fitting hole,
to rotate at the speed of normal movement of the elevator. The unit mast be fitted to the hoist with all
screws and safety washers
1
WARNING:
A PARACHUTE SHOULD NEVER BE MOUNTED ON A HOIST OF DIFFERENT
CHARACTERISTICS THAN THOSE INDICATED ON THE PLATE.
WARNING:
HANDLING AND TESTING OF THE PARACHUTE ONLY IS ONLY ALLOWED TO THE
MANUFACTURER OR AUTHORIZED SERVICE PERSSONEL.
Finally, install the safety switch wire on its correct position, according to the scheme, in order to avoid
further movement of the hoist if the safety device locks, until the actuation of technical personnel.
Once the assembly of the unit is finished, install back cover, so the device remains watertight and
mechanical characteristics of the parachute are preserved along the time. Nobody but the manufacturer
is allowed to manipulate screws of the unit itself.
©
ALBA-MACREL GROUP, S.L.
ID PLATE ON THE PARACHUTE
5 5
2
3
5
5
4
INSTALLING SAFETY UNIT IN TO THE HOIST
USER´S MANUAL
1: PARACHUTE
2: PARACHUTE PINION
3: SAFETY WASHER
4: SAFETY PIN
5: SAFETY SCREW
6: FITTING SCREWS
Pag. 47
Advertisement
Table of Contents
