Table of Contents
Advertisement
Rack and pinion transport platform PT-450
NEGATIVE FLOORS
IMPORTANT:
THE HOIST ALLOWS TO DISPLAY NEGATIVE FLOORS. DEFINING NEGATIVE
FLOORS DISPLACES. REF. POINT TO THE LOWEST POINT OF THE ROUTE.
NEGATIVE FLOORS ONLY AFFECT THE DATA SHOWN ON THE DISPLAY.
• Step 1. Select MANUAL mode.
• Step 2. Place the hoist in reference point FCB
• Step 3. Process:
+
SELEC. FLOOR
NEGATIVE (MAX. -9)
• Step 4. Release KEY
1 x
IMPORTANT:
WHEN DEFINING NEGATIVE FLOORS, REFERENCE POINT IS DEFINED ON THE
LOWER FLOOR. WHEN PROGRAMMING MAX. NUMBER OF FLOORS MUST BE
TAKEN INTO ACCOUNT OF NEGATIVE FLOORS.
Example: PTO. REF .: -5, P.MAX: 15" THE DISPLAY SHOWS ONLY: -5 ÷ 10
Step 13. Installing landing levels call system – OPTION
ATTENTION:
CALLING THE HOIST FROM THE FLOORS WILL ONLY BE POSSIBLE WHEN THE
HOIST IS FREE (GREEN PILOT OFF).
E-CPC-A CARD FOR FLOOR CALLS MANAGEMENT ON INFERIOR CONTROL BOARD
©
ALBA-MACREL GROUP, S.L.
2x
+
MEMO NEW REFERENCE POINT
IN NEGATIVE FLOOR
USER´S MANUAL
OK
Pag. 31
Advertisement
Table of Contents
