Step 12 Programming Landing Levels - Alba PT-450 User Manual

Rack and pinion transport platform PT-450
Step 12. Programming landing levels.
PROGRAMMING OPERATIONS ARE CARRIED OUT FROM THE CABIN
SWITCHBOARD.
IN EVERY NEW ASSEMBLY, OR IF THE ER E2 MESSAGE APPEARS, YOU MUST
PROCEED REBOOT THE MEMORY OF THE CPU.
DELETE MEMORY / INITIALIZATION
• Step 1. Select MANUAL mode.
• Step 2. Place the elevator in the Reference Point (INFERIOR ENDTRACK LIMIT) (FCB).
• Step 3. Process:
+
SEL.. 00
1 x
• Step 4. Release KEY:
MAXIMUM FLOOR PROGRAMMING
ATTENTION:
THE CONTROL ALLOWS TO MEMORIZE THE NUMBER OF FLOORS THAT HAVE
BEEN INSTALLED, TO PREVENT THAT A FLOOR BE SELECTED IN OPERATION
ABOVE THE LAST INSTALLED CAM.
• Step 1. Select MANUAL mode.
• Step 2. Press up from the cabin control until you leave the Reference point FCB (a few cm.)
• Step 3. Process:
+
SELEC. Nº FLOORS
INSTALLED (MAX. 84)
• Step 4. Release KEY.
1 x
IMPORTANT:
AFTER SAVING MAXIMUM NUMBER OF FLOORS, THE HOIST MUST BE DOWN TO
FCB IN "MANUAL" MODE. AFTER CHANGING TO "AUTO" MODE YOU WILL BE
ABLE TO START WORKING.
Pag. 30
ASSEMBLY OF THE MACHINE
2 x
+
INITIALIZATION
PTO. REF. OK
2 x
+
MEMO Nº MAX. FLOORS OK
OK
OK
Rev.1.0