Checking Hoist Operation Before Commisioning; Applications And Uses Forbidden - Alba PT-450 User Manual

Rack and pinion transport platform PT-450
3.6. Checking hoist operation before commissioning.
IMPORTANT:
BEFORE HOIST COMMISSIONING, HOIST SERVICE RESPONIBLE WILL CHECK IF
HOIST IS IN COMPLIANCE WITH FOLLOWING POINTS:
•
Hoist ´s installed with all operational safety systems:
o Landing floor are properly programmed
o No destination can be chosen over last floor programed.
o FCS microswith stops hoist before reaching red mast.
o Overload detector (inductive sensor) works properly
o Brakes support the maximum load correctly.
o FCB microswitch stops hoist on Ref. Point before reaching buffers.
o The mast presence detector works correctly.
o Display shows safety activations and operacional leds correctly.
o Landing levels hoist calling system works OK (if installed.
o Hoist control inside cage works properly
•
There´s no interference of hoist and external items, mast, ties, supporting structure,..
•
Landing doors are installed and there´s no interference with hoist mobile elements.
•
Base fence is installed and there´s no interference with hoist mobile elements.
•
Door releasing system for cage door / landing door / fence door are operative.
•
Control microswitch for cage door / landing door / fence door work correctly
•
The points of access to the platform and hoistway have adequate lighting.
IMPORTANT:
KEEP ORDER AND CLEANING IN THE ELEVATOR AND SURROUNDINGS

3.7. Applications and uses forbidden

• DON´T use the hoist on explosive atmospheres.
• DON´T use the hoist with higher load than shown in the plate
• Load CAN´T be piled up at the cage floor bounds, it must be located as near from mast as possible.
• DON´T transport loads out of cage floor.
• DON´T use the hoist in adverse weather conditions, rain, ice, snow, (See Ap. 1.3) ...
©
ALBA-MACREL GROUP, S.L.
1
1
USER´S MANUAL
2
2
2
Pag. 43