Advertisement
1
Guide post
2 Groove
d With the riser card and connector properly aligned, press down on the top of the PCIe cage to seat the riser card in
the connector.
e Press down on the fastener and turn the fastener tab one half turn (180°) clockwise to secure the PCIe cage.
5 Remove the empty secondary PCIe cage (right), if present, from the new controller.
Note: The Alletra 6010 model does not include a secondary PCIe cage. For 6010 models, proceed to Step 7.
a Lift the tab of the fastener and turn the fastener one half turn (180°) counter clockwise to release the PCIe cage.
b Grasp both sides of the PCIe cage and lift the cage out of the controller.
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
3
Riser card
Replace a Controller 7
Advertisement
