Advertisement
1
OCP card
b Remove the slot cover from the OCP expansion slot on the back of the controller.
c Gently insert the OCP card into the expansion slot of the replacement controller.
Be sure the OCP card is properly seated.
d Engage the OCP card latch to secure the card in the slot.
Note: LEDs on the OCP card do not light until cables are connected and establish a link.
8 Move the power supplies from the failed controller to the new controller.
a Push the power supply release lever to the left, grasp the handle, and pull the power supply out of the bay.
1
Power supply release lever
b Slide the power supply into a bay of the new controller until it clicks into place.
c Repeat this action with the other power supply. A power supply can be installed in either bay of the new controller.
9 Install the controller into the chassis.
a Make sure the controller release levers are fully extended.
b Slide the controller into the chassis bay. Do not force the controller. If it does not slide in easily, remove it and try again.
c After the controller is in place, return the controller release levers to their original closed position, and then tighten
the thumbscrews.
d Reconnect all the network cables to the controller (as labeled from step 2).
e Reconnect the power cables to both power supplies.
10 Verify that the controller is powered on.
2
OCP card latch
2
Power supply handle
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
Replace a Controller 10
Advertisement
