Adjusting The Riding Sag - KTM 350 SX-F 2023 Owner's Manual

10.10

Adjusting the riding sag

Main work
–
Loosen screw
–
Turn adjusting ring
sion.
Hook wrench (90129051000)
Info
If the spring cannot be fully released, the spring must be
removed to accurately measure the spring length.
–
Measure the total spring length while the spring is not under
tension.
–
Tension the spring by turning adjusting ring
A
dimension
Guideline
Spring preload (SX‑F EU/AR)
Spring preload (SX‑F US)
Spring preload (All XC‑F
F03627-10
models)
Info
Depending on the static sag and/or the riding sag, it
may be necessary to increase or decrease the spring
preload.
–
1
Tighten bolt
Guideline
Screw, shock
absorber adjusting
ring
Finishing work
–
Install the shock absorber.
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
–
Install the frame protector. (
–
Install the main silencer. (
Preparatory work
–
Remove the frame protector. (
–
Remove main silencer. (
–
Raise the motorcycle with a lift stand. (
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
TUNING THE CHASSIS 10
1
.
2
until the spring is no longer under ten-
.
8 mm (0.31 in)
8 mm (0.31 in)
8 mm (0.31 in)
.
M5 5 Nm (3.7 lbf ft)
( p. 69)
p. 57)
p. 76)
p. 57)
p. 76)
p. 53)
( p. 68)
2
to specified
p. 97)
p. 53)
43