KTM 350 SX-F 2023 Owner's Manual page 53

Adjusting the handlebar position with the handlebar clamp (All standard
models)
–
Place the handlebar support in the required position.
Info
The handlebar support is longer and higher on one
side.
–
Mount and tighten the screws
Guideline
Screw, handle-
bar support
Rigid handlebar support bushing (A46001038010)
The conical side of bushing faces downwards.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
A01170-10
–
Position handlebar clamp
–
Mount screws
–
First bolt the handlebar clamp with screws
longer, higher side of the handlebar supports so that both
parts touch.
–
Tighten screws
Guideline
Screw, handlebar
clamp
(350 XC‑F US Factory Edition)
–
Remove screws
off the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables or lines.
–
Remove screws
3
support
Adjusting the handlebar position with the handlebar clamp in the rubber
bearing (350 XC‑F US Factory Edition)
–
Position the rubber bushings
–
Place the handlebar support in the required position.
Info
The handlebar support is longer and higher on one
side.
F03635-10
–
Mount and tighten the screws
TUNING THE CHASSIS 10
7
with the bushings
M10 40 Nm (29.5 lbf ft)
2
.
1
, but do not tighten yet.
1
evenly.
M8 20 Nm
(14.8 lbf ft)
1
. Take off handlebar clamp
7 6
and bushing . Take off handlebar
.
4 5
and
7
with bushing
8
.
Loctite ® 243™
1
onto the
2
. Take
.
6
.
51