Installing the bat-
tery
99
3.
Release the small tab (c), and press the bat-
tery upwards to remove the battery from the
holder.
1.
To install the battery, loosen the two locking
screws (a) below the rear handle and pull out
the Handle and Battery Assembly (b).
2.
The battery sits in a holder that is part of the
handle assembly. Turn the Handle and Battery
Assembly upside-down.
3.
Press the battery into the holder until the
small tab (c) locks the battery in place.
4.
Turn the Handle and Battery Assembly over and slide the it into the
rear of the Piper. The gold contacts (d) should be facing up as shown.
5.
Tighten the two locking screws (a) firmly to ensure a good, watertight
sealing.
Accessories
d
b
a
c