Table of Contents
Advertisement
90
Standard Setup Procedures
1.
Remove the four feet from the Piper, then
attach the mounting plate (a) by re-installing
the feet.
2.
Attach the Scope and mount (b) to the top of
the Piper using the two screws and hex driver
supplied with the scope.
3.
Attach the Piper to the tripod and tighten it
securely
4.
Set the cross-hairs of the scope on a target
and then adjust the beam to the target using
the LEFT and RIGHT arrow buttons on the
Piper or on the remote control.
b
a
Advertisement
Table of Contents
