Table of Contents
Advertisement
78
Basic Operation
Procedure for using Alignmaster:
1.
Position the target assembly in the end of the
last piece of pipe with the two reflective strips
on the inside of the pipe, facing the laser.
2.
Roughly align the laser beam in the pipe to
the target assembly.
3.
Press the ALIGNMASTER button (a). When pressed the laser will scan
left and right until the target is found. While searching, the main oper-
ating screen is replaced with a blinking target (b) indicating that
Alignmaster is working.
4.
If the search routine is successful, the target will remain on the screen
for an additonal five seconds (not blinking).
5.
The beam can now be fine-positioned to the centre of the target using
the LEFT or RIGHT arrow button (c) on the laser or the remote control.
The Alignmaster routine can be interrupted at any time by pressing the
☞
ALIGNMASTER button a second time. The line position will return to its
original position.
a
b
c
Advertisement
Table of Contents
