Table of Contents
Advertisement
80
Setting up the Tar-
get Assembly
Basic Operation
The red Target Assembly (725858) and the blue Target Assembly
☞
(915443) include the small target insert.
1.
Slide the required Target Insert into the Tar-
get Assembly.
2.
Loosen the locking knob and insert the target
with the printed side of the target on the
same side as the level vial.
3.
Place the target into the end of the pipe. The
reflective strips should be facing the laser,
towards the inside of the pipe.
4.
Adjust the Target in the pipe until the bubble
is centred in the level vial.
Advertisement
Table of Contents
