Table of Contents
Advertisement
82
Typical Second Day
Setup
Basic Operation
5.
Set the elevation. Loosen the handle on the mounting bracket. Slide
the bracket and laser up or down until the desired elevation is
achieved. The slide bracket is made of a special material to ensure
smooth movement. Tighten the handle to lock the elevation in place.
The following is a brief description of a typical second day setup.
1.
Press the POWER button to turn the unit on.
2.
Set the Grade. The Piper remembers the last-used grade from the pre-
vious day.
Check the display to ensure that the grade has not been changed.
3.
Set the Elevation. Place the Piper where it was the previous day.
Rotate the Piper until the bubble in the cross-axis level vial is centred.
4.
When placing the Piper in the pipe, ensure that the proper feet are
attached and that the cross-axis bubble is centred.
5.
Set the line. Follow the line of the pipe laid the previous day.
6.
Place the target assembly in the last piece of the pipe laid and adjust it
in a way that the bubble is centred in the level vial.
7.
Adjust the line of the laser beam using either the LEFT and RIGHT but-
tons on the Piper or on the remote control.
Press the button until the laser beam is centred on the target
Advertisement
Table of Contents
