Time Electronics 7000 User Manual page 12

Rtd calibrator
Table of Contents

Advertisement

Time Electronics
7000 RTD Calibrator
To change the Zero & Span refer to Setup procedure Section 5.1.
To calibrate using the Manual Step Function refer to Section 4.3.
To calibrate using the Ramp Function refer to Section 4.4.
Error messages
The display shows over range ^^^.^^ or Output unable to settle:
Incorrect wiring. Check polarity.
Excitation current from the circuit under test is too high or low. Range is 600µA to
1mA depending on the probe type.
Circuit under test is multiplexed.
12
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 7000 and is the answer not in the manual?

Table of Contents