Table of Contents
Advertisement
DWR-956 Wireless AC1200 4G LTE Router
with Gigabit Ethernet Ports and 1 FXS Port
User Manual
LAN
To configure the router's local interface, go to the Connections Setup / LAN page.
IPv4
Go to the IPv4 tab to change the IPv4 address of the router, configure the built-in DHCP server,
specify MAC address and IPv4 address pairs, or add own DNS records.
Figure 91. Configuring the local interface. The IPv4 tab. The Local IP Address section.
Parameter
Mode of local IP
address assignment
IP address
Mask
Local IP Address
Available if the Access point, Repeater, or Client mode was
selected in the Initial Configuration Wizard.
Select the needed value from the drop-down list.
Static: The IPv4 address, subnet mask, and the gateway IP
•
address are assigned manually.
Dynamic:
•
parameters from the LAN DHCP server or from the router to
which it connects. When this value is selected, the controls
of the Dynamic IP Addresses section are not available.
Also when this value is selected, the Obtain DNS server
addresses automatically switch is displayed on the tab.
The IPv4 address of the router in the local subnet. By default, the
following value is specified: 192.168.0.1.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Page 106 of 302
Configuring via Web-based Interface
Description
The
router
automatically
obtains
these
Advertisement
Table of Contents
