Advertisement
Available languages
Available languages
MAINTENANCE
Stylus
Before playing a record, clean the stylus with a soft brush.
Brush
the stylus from back to front.
Never attempt to clean the stylus
with your finger tip.
If a fluid stylus cleaner is used, make sure not
to moisten the stylus too much.
Cabinet
Clean
the cabinet
and
dust
cover
periodically
with a soft dry
cloth.
If the stains are difficult to remove, use a cloth moistened
with
a mild detergent
solution.
Do not use solvents
such
as
alcohol, benzine or thinner, since they will damage the finish.
Rubber mat
When the rubber mat becomes dirty, wipe it gently with a soft cloth
slightly dampened with water.
Lubrication
The turntable requires no periodic lubrication. The motor shaft is
lubricated at the factory for the life of the turntable.
SPECIFICATIONS
Turntable
Platter
32 cm (125/s in.), aluminum-alloy diecast
Motor
Linear BSL (brushless and slotless) motor
Direct drive
Quartz lock control, magnedisc servo
control system
Speed
3343 rpm, 45 rpm
Starting characteristics
Comes to nominal speed within a
half revolution (33%/3 rpm)
0:015 (WRMS)* 0.025% (WRMS)
+0.03% (DIN)
Signal-to-noise ratio 78 dB (DIN-B)
Load characteristics 0% up to 150 g stylus force (at lead-in
groove of a record)
Within +0.003%
Drive system
Control system
Wow and flutter
Speed deviation
Tonearm
Type
Electronic tonearm
Pivot-to-stylus length 216.5 mm (8*/s in.)
Overall arm length
295 mm (11%/s in.)
Overhang
16.5 mm (24/32 in.)
Tracking error
+3°,-1°
Stylus force adjustment range
O-3g
Cartridge shell weight
5g
p
Cartridge weight range (including supplied cartridge shell)
7.5-12.5g
12-17
(with extra weight)
General
Power requirements
Type 1: 220V ac
Type 2: 240 V ac
Type 3: 110-120 or 220-240 V ac adjustable
50/60 Hz
Power consumption
13W
Dimensions
Approx. 430 x 120 x 385 mm (w/h/d)
(17 x 43/4 x 1544 in.)
including projecting parts and controls
Weight
Approx. 8.3 kg (18 Ibs 5 02), net
Approx. 9.8 kg (21 Ibs 10 02), in shipping
carton
:
Supplied accessories
45-rpm adaptor (1)
Extra weight (1)
Cartridge shell (1)
Cartridge mounting screws (1 set)
Note
Appliance conforms
with
EEC
Directive 76/889 regarding
inter-
ference suppression.
* This new measuring
method
concerns
only the turntable assembly, in-
cluding the platter.
It excludes wow and flutter caused by the tonearm, the
cartridge, or the record.
Measured by obtaining signal from magnetic pick-
up head.
Advertisement
