Advertisement
Available languages
Available languages
RECORD PLAYING—<Auto play
Connection to an amplifier
Set the input selector to PHONO and
turn down the volume.
Place a record.
to a ground
Hee
aaa
For a 45-rpm record,
terminal
Red plug to R
White plug to L
to an ac outlet
use the supplied
adaptor.
|
to an ac outlet
|
Press |
—as-
st SPEED
For a 45-rpm record, press this button.
Lift up
'
sie | =
the stylus JE)
cover.
MOTOR ON/OFF
The turntable starts to rotate.
Unlock the
arm rest.
Bring the tonearm onto a record.
(
Turn up the amplifier
The stylus is lowered
volume.
onto the record.
When the tonearm reaches the end of the record, it is
lifted up automatically and the turntable stops rotating.
Secure the tonearm to the arm rest.
& @ N
TO STOP DURING PLAY
@ Press the Y/ VY button to lift up the tonearm.
@ Press the MOTOR ON/OFF button to stop the turntable.
© Secure the tonearm to the arm rest.
:
TO LIFT UP THE STYLUS DURING PLAY
Press the Z/ V button.
To start playing
from the same
point, turn down
the amplifier
volume and press the
W/V button. After the tonearm lowers onto
the record, turn up the volume.
OVERHANG
CHECK*
Check that.the cartridge is correctly installed, using the alignment
gauge on the underside of the rubber mat.
@ Place the rubber mat upside down, and turn on the power.
_ @ Bring the tonearm over the point where the two fine lines cross
and carefully lower the stylus to this point by pressing the W/V
button.
6
© Check to see that the head shell is parallel to the lines marked on
the rubber mat, as shown in the illustration.
If itis not, loosen the
cartridge mounting screws and slide the cartridge to the required
position.
Tighten the screws and recheck the balance and stylus
force.
>|
|
Correct overhang
* Overhang
While record grooves are cut by a head which tracks a record's radius in a
line, a ionearm, because it is pivoted, traces an arc on arecord.
To compen-
sate for this difference in movement, the head shell is angled and the car-
tridge is installed with a 16.5 mm overhang.
(See the illustration.)
The cor-
rect overhang is obtained by installing the cartridge with a 37.5 mm space
between the stylus tip and the end of the cartridge shell and by checking the
installation with the alignment gauge.
Advertisement
