Antenna Header Contact, Accessory Seal - Motorola iDEN i265 Field Service Manual

PREPARING FOR FIELD LEVEL TESTING: Antenna Header Contact, Accessory Seal
7.7

Antenna Header Contact, Accessory Seal

7.7.1 Remove Antenna Header Contact
Equipment Required: Black stick
1. Wedge pointy tip of black stick under antenna header contact located near antenna port.
See Figure 7-11.
2. Work and lift carefully until antenna header contact pops out.
7.7.2 Install
Do not damage contact while repositioning.
7.7.3 Remove Accessory Seal
1. Lift flap portion of seal while gently pulling seal towards antenna end of unit. Seal should peel
off without damage. See Figure 7-12.
7.7.4 Install
1. Press square hole of seal onto square post on housing.
2. Press on seal while pushing flap down towards bottom of unit. Seal should hold "kickstand"
position.
Figure 7-11.
7-10
Figure 7-12.
68P80400P84-O