Table of Contents
Advertisement
6.2.2
ESN and IMEI Matching Test
Use this test to verify that the electronic serial number (ESN) matches the International Mobile
Equipment Identifier (IMEI) on the Serial Number label located on the chassis of the unit.
The ESN and IMEI Matching Test time is approximately 6 minutes.
1. Power up the unit. Wait until the power-up sequence is complete before continuing.
2. Enter debug mode. The Unit Info display appears.
3. Scroll down until the IMEI/SIM ID choice is highlighted, then press View to view the IMEI/
SIM ID display.
4. Write down the digits shown in the IMEI line.
5. Verify that this number matches the IMEI on the Serial Number label. The last zero on the label
will be missing.
If the numbers do not match, process the unit to the next servicing tier.
6.2.3
Engineering Debug Check
Use this test to monitor (measure) the data in an i265 unit.
NOTE: The following procedure describes the sequence of displays accessed via the down scroll
key. If you press the up scroll key, the sequence appears in reverse order.
To monitor the data in the unit:
1. Power up the unit. Wait until the power-up sequence is complete before continuing.
2. Enter debug mode. The Unit Info display appears.
a. Press View to view the Phone Model display, and then press Select to view the phone
model, such as i265.
b. Press Back to return to the Unit Info display, and then scroll down (down scroll key) to
highlight the CP Ver choice.
c. Press Select to view the Codeplug Version. The first half of the line displays the codeplug
structure and default version; the second half displays the codeplug bandmap.
d. Press Back to return to the Unit Info display, and then scroll down to highlight the CSD
Ver choice.
e. Press Select to view the Customer Static Data version. The first number indicates the
customer. The second number indicates the structure revision. The third number indicates
the data revision.
f.
Press Back to return to the Unit Info display, and then scroll down to highlight the
Software choice.
68P80400P84-O
BASIC LEVEL TEST MODES AND PROCEDURES: Test Mode Test Procedures
6-5
Advertisement
Table of Contents
Troubleshooting
