Esn And Imei Matching Test; Engineering Debug Check - Motorola iDEN i530 Field Service Manual

12. Press the Stop key to end the test.
6.2.2

ESN and IMEI Matching Test

Use this test to verify that the electronic serial number (ESN) matches the International
Mobile Equipment Identifier (IMEI) on the Serial Number label located on the chassis of the
unit.
To perform the matching test (test time approx. 6 min.):
1. Power up the unit. Wait until the power-up sequence is complete before continuing.
2. Enter debug mode. The Unit Info display appears.
3. Scroll down until the IMEI/SIM ID choice is highlighted, then press View to view the
IMEI/SIM ID display.
4. Write down the digits shown in the IMEI line.
5. Verify that this number matches the IMEI on the Serial Number label. The last zero on
the label will be missing.
If the numbers do not match, send the unit to the field level of service.
6.2.3

Engineering Debug Check

Use this test to monitor (measure) the data in an i530 unit.
NOTE: The following procedure describes the sequence of displays accessed via the down
scroll key. If you press the up scroll key, the sequence appears in reverse order.
To monitor the data in the unit:
1. Power up the unit. Wait until the power-up sequence is complete before continuing.
2. Enter debug mode The Unit Info display appears.
a. Press View to view the Phone Model display, and then press Select to view the
phone model, such as i530.
b. Press Back to return to the Unit Info display, and then scroll down (down scroll key)
to highlight the CP Ver choice.
c. Press Select to view the Codeplug Version. The first half of the line displays the
codeplug structure and default version; the second half displays the codeplug
bandmap.
d. Press Back to return to the Unit Info display, and then scroll down to highlight the
CSD Ver choice.
e. Press Select to view the Customer Static Data version. The first number indicates the
customer. The second number indicates the structure revision. The third number
indicates the data revision.
68P80400P65-O
BASIC LEVEL TEST MODES AND PROCEDURES: Test Mode Test Procedures
6-5