Account Settings Page Definitions; Account - General Settings; Account - Network Settings - Grandstream Networks GAC2500 Administration Manual

Account Settings Page Definitions

GAC2500 supports 6 accounts, The Account pages lists General Settings, Network Settings, SIP Settings, Codec & RTP Settings
and Call Settings.
Account – General Settings
Table 23: Account – General Settings
Account Active
Account Name
SIP Server
SIP User ID
SIP Authentication ID
SIP Authentication
Password
Voice Mail Access Number
Name
Show Account Name Only
Tel URI
Account – Network Settings
Table 24: Account – Network Settings
Configures the IP address or the domain name of the primary outbound proxy, media gateway or session
Outbound
border controller. It's used by the phone for firewall or NAT penetration in different network environments. If
Proxy
a symmetric NAT is detected, STUN will not work and only an outbound proxy can provide a solution
Secondary Sets IP address or domain name of the secondary outbound proxy, media gateway or session border
Outbound controller. The phone system will try to connect the Secondary outbound proxy only if the primary outbound
Proxy proxy fails.
Indicates whether the account is active. The default value for the primary Account
1 is "Yes" and the default value for the other five accounts is "No".
Configures the name associated with each account to be displayed on the LCD.
Specifies the URL or IP address, and port of the SIP server. This is provided by
your VoIP service provider (ITSP).
Configures user account information provided by your VoIP service provider
(ITSP). It's usually in the form of digits similar to phone number or actually a
phone number.
Configures the SIP service subscriber's Authenticate ID used for authentication. It
can be identical to or different from the SIP User ID.
Configures the account password required for the phone to authenticate with the
ITSP (SIP) server before the account can be registered. After saving, it will appear
as hidden for security purpose.
Sets if the phone system allows users to access the voice messages by pressing the
Voicemail icon on the GAC2500. For example, in UCM6xxx IPPBX, *97 could be
used.
The SIP server subscriber's name (optional) that will be used for Caller ID display.
Defines whether to display account name and SIP User ID, if check, it only
displays account name on account area.
If the phone has an assigned PSTN telephone number, this field should be set to
"User=Phone". Then a "User=Phone" parameter will be attached to the Request-
Line and "TO" header in the SIP request to indicate the E.164 number. If set to
"Enable", "Tel:" will be used instead of "SIP:" in the SIP request. The default
setting is "Disable".